Tools Needed

***Put the mouse cursor over images to enlarge

  1. Open your trunk and remove the Passenger rear tail light carpet/cover by loosening the cargo net thumb screws .
  2. Lower your tail lens onto the bumper. Notice the locations of the four thumb screws. Use a towel under the light to avoid scratching bumper.
  3. Notice that we have the inside light (grey plastic) labeled L1 the middle L2 and the outside L3. Locate the Orange with blue stripe wire labeled MAJOR on the connector for L2 and L3, cut and strip.

  4. Twist the two wires that are coming from the harness together. Grab one tail light module; take the blue wires and crimp them to the two orange and blue stripped wires that are both comning from the harness.

  5. Remove L1 socket from the tail lens and take a pocket screw driver to pry out the blue weather seal from the bottom of the connector. Poke a hole into the seal to allow for the third blue wire to be installed.

  6. Take the blue wire with the pre-soldered blade connector and slip it through the hole you just made in the weather seal. Take your needle nose pliers and firmly insert the blade connector into the empty slot in the tail light bulb socket. (labeled "Major") Gently pull back to make sure that your terminal is securly fastened into the light socket and them re-seat your connector weather seal.




  7. Attach your orange wire from your tail light module to L2. (Previously cut L2 orange/blue "Major" wire)
  8. Attach your red wire from your tail light module to L3. (Previously cut L3 orange/blue "Major" wire)
  9. Locate the L3 sockets Black wire, labeled "GND". Cut the wire and strip both ends. Twist together and attach them to the black wires coming from your tail light module. This should be your last wiring connection for this side of your car.

  10. Re-connect any loose light sockets to lens and be sure to tape all connections very well. Module can be tucked into various positions behind the tail lens. Secure with zip-ties or Electrical tape and re-assemble tail lens to car.

  11. Your drivers side module install is the same as what you have just accomplished, with one minor change. The light sockets are labeled the same: inside light L1, middle L2, outside light L3 and all the wiring connections remain the same. The only change is that you have two Green with Orange strip wires labeled MAJOR on L2 and L3 instead of two Orange with blue strips.
  12. **Your car must be RUNNING for proper operation of the modules. Make sure your car is RUNNING while you do your testing**

    If you are having any trouble with your install, please go to the Forums for Frequently asked questions and support